Risk Racing® - Fusion 2.0 Grips with Fusion Bonding System

Wave Ergonomics
The large flange of the moto grip has a slight bend to it. This bend reduces pressure points between the riders' thumb and the grip flange, preventing blisters on the side of your thumb.

Gripping Ribs
The Moto grip features three minimal, but meaningful, ribs on the bottom side of the grip. These three ribs interact with your last two fingers, which provide most of the gripping power in your hand.

Dual Compound
Premium, dual compound grip that feature great vibration damping and durability.The ends of these grips are double walled reinforced to prevent damage during tip overs.

Fusion Bonding System
Fusion Grips include the Fusion Bonding System kit. At 1st the Fusion Spray acts as a lubricant for easy grip installation, but after it dries, it creates a lasting bond. The entire process is clean and simple, and bonds in about 10-15 minutes. Removal of the grips is the same process as any other grip.

If you ride a dirt bike then you know what it is like to have a grip that slips. Despite all your best efforts to properly glue and safety wire the grip securely in place, it inevitably slips creating an annoyance and a safety hazard.

The act of gluing and wiring grips with specialty tools can be a hassle as well. The wire often breaks leaving a sharp point and wreaks havoc on both your hands and the grip. The gluing process is a mess and difficult to get consistent coverage between your grip and the bar due to the fact that the grip just pushes all the glue to one end or the other.

Risk Racing has a simple and effective solution. Risk Racing are introducing the patent pending Fusion Grip Tech Bonding Strips and Fusion Spray Catalyst. Simply peel and stick the bonding strips to your bars. Then spray the bonding strips with the supplied Fusion Catalyst and easily slip your grip into place. At 1st the catalyst acts as a lubricant for easy grip installation, but after it dries it creates a lasting bond. The entire process is clean and simple.

Additionally, Fusion Grip Tech comes packaged with the new Risk Racing FUSION 2.0 Ergo Wave Grips. The Wave Grips are a high quality, dual compound soft grip with a reinforced grip end and an ergonomically designed grip flange. This ergonomic "wave" on the flange of the grip reduces pressure points between the riders thumb and the grip flange. Although this patent pending design feature is subtle, it greatly reduces heat and pressure, which reduces blistering and increases rider comfort. Thanks to the Risk Racing Ergo Wave grips you can say goodbye to "Yama-thumb"!

• The ergonomic "wave" on the flange of the grip reduces pressure points between the riders thumb and the grip flange
• The design of the grips greatly reduces heat and pressure, which reduces blistering and increases rider comfort
• Easy application: clean your handlebar, apply the bonding strips, shake and spray the catalyst to the exposed bonding strips, quickly apply grips, and you're done